It only takes a few minutes to inspect and clean your boat and other equipment each time you leave the water. Knowing how to do this properly will save time and protect our waters from plants and animals that don’t belong there.
Non-native plants and animals can cause a lot of damage. Many aquatic invasives arrive via international shipping or the pet trade and are then unknowingly spread between waterways by boaters and anglers. Safe from the predators and diseases of their native habitat, these invasives often reproduce uncontrolled. Once established, they can cause many problems:
- Reduce game fish and other native wildlife populations
- Ruin boat engines and jam steering equipment
- Make lakes and rivers unusable by boaters and swimmers
- Increase the operating costs of drinking water and power plants
- Affect human health
- Reduce property values
In most cases, the best way to manage aquatic invasives is to halt their spread into new areas. That’s why cleaning your equipment every time you leave the water is so important. All you need to do is clean, drain, and dry!
Stop Aquatic Hitchhikers
Invasive plants, animals, and other organisms have made their way into waters across the United States. These non-natives can dominate aquatic ecosystems, wiping out native plants and wildlife, because they have no native predators. They can also damage boat engines and steering equipment, make lakes and rivers unusable by boaters and swimmers, and dramatically increase the operating costs of drinking water plants and power plants.
You can help. Thoroughly cleaning boats and equipment after a day on the water will prevent aquatic invaders from hitching a ride with you to a new waterway. It’s one of the most important things you can do to protect America’s wildlife and great outdoor recreation.
The U.S. Fish and Wildlife Service and U.S. Coast Guard recommend the following steps to protect your favorite fishing and boating spots from an unwanted invasion. The three key steps are: Clean. Drain. Dry. It is important to follow these procedures every time you come into contact with any body of water. Even if the waters look pristine, invasive species may be lurking under the surface – some so small that you cannot see them without a microscope.
- Remove any visible plant matter, animals, mud, and dirt from your boat, trailer, boots, fishing tackle, and all equipment that has been in the water. Even plant fragments and dirt may contain tiny hitchhikers.
- Empty water from motors, jet drives, live wells, boat hulls, canoes and kayaks, and bait buckets. Do this onsite. If you wait until you get home to empty water, it can run into a storm drain and contaminate local waters.
- Clean your equipment, including your boat’s engine cooling system, live wells, and bilge with hot tap water. If hot water is not available, spray equipment such as boats, motors, trailers, anchors, decoys, fl oats, and nets with high-pressure water.
- Equipment that cannot be exposed to hot water should be dipped in vinegar for 20 minutes or a one-percent saltwater solution for 24 hours. This table provides mixtures for the one-percent saltwater solution:
|Gallons of Water
||Cups of Salt
- Allow boats and other equipment to dry for at least 5 days before using them in other waters.
- If your dog gets into the water, wash him or her with warm tap water as soon as possible, brushing the coat thoroughly to remove any clinging invasives.
- Do not release unused bait into the waters you are fishing, whether the bait was bought at a store or caught in local waters. Dump unused bait into a trash can.